marcopolo15

Hey everyone! so today I just finished installing my new Injen Cold Air Intake! I love it, but as soon as I finish driving it for the first time I go to roll up my windows and the 'auto up' does not work (the second click on the window switch witch allows the window to automatically close all the way). Next I get out of the car after rolling the windows all the way up. They should scoot down about 1/2 and inch to clear the seal, and when you close it they go back up. When I closed it, they did not push back up in the seal. I did not mess with any of the wiring in my car, the online wire that I did touch is the wire that goes into the window washing pump attached to the tank. Has this happened to anyone? Thanks for everyone for taking your time!

VossenG37S

iTrader: (16)

Easy fix just sit in your car and hold the window button down for 15 seconds then hold it up for 15 and done ! This is how u reset it and it will be back to normal I promise

marcopolo15

SWEETTT thanks man! I will take care of it tomorrow morning!

KrazyACman

Same thing happened to me when I replaced my battery, and the local shop calmed they had a tool to hold the memories.. after everything is done, the auto up, did not work, all u have to do is to reset it. follow the instruction in the owner's booklet, there is a section teach u how to reset it properly.

Rad_Slinger

iTrader: (12)

Tells u how to do this in the owners manual (page 2-51 in my '09)

Lt8Che

iTrader: (6)

"I promise" hahaha

OB G

iTrader: (11)

Make sure your door is closed when you're doing it too, or the "up" won't work...at least it didn't for me...

Mad Nash G

Search is a good thing. Worked for me here. Cheers!

jking

i had the same problem you had the dealer ship did a reset and i still had the problem again a few days later .I told them to give me a new window control panel now i have no problems with the window

joelmd

it just worked for me. battery replacement seem to be the issue trigger.


thanks.